## 1. Hardware Package Package 1 (Temperature only):  Package 2 (Temperature and Humidity):  ## 2. WiFi Setup Very few steps to finish Wi-Fi setup.  **Step1**, Use your smart device's Wi-Fi connection setup, connect to the monitor's network, which will be shown up as eMonitor_xxxxxxxx (xxxxxxxx is the unique SN of eMonitor). No password required. > Note: Note down the Meter SN for later registration on the plarform. **Step2**, Whilst connected to the monitor's network, open a web browser and navigate to [http://11.11.11.1](http://11.11.11.1); Enter the username "admin" and password "admin". **Step3**, Connect to home router by clicking "WiFi Networks" or manually input home router's SSID (your home Wi-Fi networks' SSID) and Key (your home Wi-Fi networks' password) and then click "Save&Reboot" **Step4**, After rebooted, the page will be shown as below.  **Step5**, If the Wi-Fi monitor successfully connected to your home router after configuration, its Wi-Fi network will be disappeared. You can find the Wi-Fi monitor in your PC's network, which will be shown up as eMonitor_xxxxxxxx (xxxxxxxx is the unique SN of eMonitor).  For next step, if you will monitor the data on DeviceBit Cloud, please refer to [Chapeter 4: Operation on Cloud](/doc/htmonitor/operation-on-cloud.html); if you will upload the data to your own server, please refer to [Chapeter 5: Connect to Your Own Server](/doc/htmonitor/operation-on-cloud.html); if you will monitor the data locally via LAN on your PC, please refer to [Chapeter 6: Monitor Locally via LAN](/doc/htmonitor/operation-on-cloud.html).